Description
The power supply is factory preset at the customer specified output voltage.
Mains input is via a 3-pin plug and flex; output terminals for + and – connections are provided outside the case.
The power supply is not recommended for float charging batteries above 60AH capacity (at C/20 rate).
Installation
The power supply should be installed in a well ventilated area and not enclosed where excessive heat build up can occur. Do not install or mount above any hot air discharge/air-conditioner/radiator or similar equipment. Mounting outside or in a wet/damp environment is also not recommended. Keep fan intake/output vents well clear of any material likely to block them.
Batteries
The above power supply is not suitable for charging the battery.
Specifications
| Inrush Current | Cold Start, 20A/115V, 40A/230V |
|---|---|
| Input Leakage Current | <0.7mA/230VAC |
| Load Regulation | <0.5% |
| Line Regulation (Full load) | < ±0.5% |
| Output Over Voltage Protection | 115~150% |
| Output Over Load Protection | 110~150% |
| Withstand Voltage | I/P-O/P: 3.0KVAC/1min |
| Rise, Hold Up Time | 50ms, 20ms @ Full Load (Tipical) |