Description
The power supply is factory preset at the customer specified output voltage.
**The power supply can be directly used as battery charger .**
Installation
The power supply should be installed in a well ventilated area and not enclosed where excessive heat build up can occur. Do not install or mount above any hot air discharge/air-conditioner/radiator or similar equipment. Mounting outside or in a wet/damp environment is also not recommended. Keep fan intake/output vents well clear of any material likely to block them.
Batteries
Sealed and open lead acid batteries can be charged. Please specify nominal output float voltage and size of battery when ordering.
Specifications
| Inrush Current | 60A/230V |
|---|---|
| Input Leakage Current | <0.7mA/230VAC |
| Load Regulation | <0.5% |
| Line Regulation (Full load) | < ±0.5% |
| Output Over Current Protection | 110~130%, Current Limiting, Auto Recovery |
| Output Over Voltage Protection | 110~150% |
| Output Over Load Protection | 110~150% |
| Withstand Voltage | I/P-O/P: 1.5KVAC/1min |
| Rise, Hold Up Time | 50ms, 20ms @ Full Load (Tipical) |