Description
For 110V AC operation contact ETE.
The power supply is factory preset at the customer specified output voltage (usually 13.8 DC or 12V DC).
Mains input is via a 3-pin plug and flex; output terminals for + and – connections are provided outside the case.
The power supply is not recommended for float charging batteries above 60AH capacity (at C/20 rate).
Installation
The power supply should be installed in a well ventilated area and not enclosed where excessive heat build up can occur. Do not install or mount above any hot air discharge/air-conditioner/radiator or similar equipment. Mounting outside or in a wet/damp environment is also not recommended. Keep fan intake/output vents well clear of any material likely to block them.
Specifications
| Output Ripple Voltage @ Full Load | < 0.5% |
|---|---|
| Load Regulation (Zero to Full Load) | < 2.0% |
| Line Regulation (220-240V) @ Full load | < 0.1% |
| Short Circuit Current Limit | 35A DC (approx) |
| Input Fuse | 6A Slow Blow 250V AC internally accessible |
| Output Fuse | 20A HRC Fuse internally accessible |
| Thermal Protection | Internal protection circuitry on board |
| Indication Lamp | Power on LED |
| Input Current @ 230V AC | 2.3A rms |