Description
The power supply is factory preset at the customer specified output voltage (usually 27.6 DC or 24V DC).
Mains input is via a 3-pin plug and flex; output terminals for + and – connections are provided outside the case.
The power supply is not recommended for float charging batteries above 60AH capacity (at C/20 rate).
Installation
The power supply should be installed in a well ventilated area and not enclosed where excessive heat build up can occur. Do not install or mount above any hot air discharge/air-conditioner/radiator or similar equipment. Mounting outside or in a wet/damp environment is also not recommended. Keep fan intake/output vents well clear of any material likely to block them.
Batteries
Sealed and open lead acid batteries can be charged. Please specify nominal output float voltage and size of battery when ordering.
Specifications
| Output Ripple Voltage @ Full Load | < 0.5% |
|---|---|
| Load Regulation (Zero to Full Load) | < 2.0% |
| Line Regulation (220-240V) @ Full load | < 0.1% |
| Short Circuit Current Limit | 15A DC (approx) |
| Power Factor @ Full Load, 200V AC Input | > 0.99 |
| Input Fuse | 6A Slow Blow 250V AC internally accessible |
| Output Fuse | 20A HRC Fuse internally accessible |
| Thermal Protection | Internal protection circuitry on board |
| Indication Lamp | Power on LED |
| Input Current @ 230V AC | 2.3A rms |
